Water-Based Duct Sealant 10.6 oz. (Gray)

APPLICATIONS

DP 1010 is recommended for sealing joints, seams, duct wall penetrations, and connections on flexible duct or fiberglass ductboard.

A smooth, water based, premium quality, UL Listed, high pressure/high velocity duct sealant for commercial and residential supply and return air duct use.

FEATURES & BENEFITS

• LEED V4 Qualified
• ZERO VOC’s
• UL Listed
• Excellent Workability
• Crack and Peel Resistant
• Mold and Mildew Resistant
• Excellent Dry Adhesion & Sag Resistant
• Indoor and Outdoor Usage
• Excellent Water and U.V. Resistance
• Collaborative for High Performance Schools Approved
• Meets CDPH Emission Requirements
• Meets FDA, USDA, and EPA Standards
• Meets Requirements of NFPA 90A & 90B, ASTM E-84, and UL-723
• Paintable with latex or epoxy paints after cured
• Color: Gray
• Base: Water
• Chemical Family: Synthetic Latex
• Solids Content: 70 ± 2%
• Viscosity: Approx. 300,000 - 400,000 cps
• Shore A Hardness: Greater than 20
• Application Temperature: 40°F - 110°F
• Storage: 40°F - 110°F. Do not freeze. If product freezes, allow to
• return to room temperature before applying.
• Freeze/Thaw Stability: 5 cycles no deterioration (DPTM-20)
• Service Temperature: -25°F - 200°F
• Flammability: Non-flammable wet or dry
• Flash Point: No flash to boiling
• Shelf Life: 2 Years (unopened containers)
• Cure Time: 24-72 hours depending on temperature, humidity, and
• application
• Coverage: Dependent on application thickness, 40-80 sq. ft. at
• 20-40 wet mils
• Clean Up: Use warm water and soap
• Packaging: 1/12 gallon tubes, 1 gallon pails, 2 gallon pails,
• 5 gallon pails, 54 gallon drums
• Pressure Classes: Meets all SMACNA pressure classes
• Seal Classes: Meets all SMACNA seal classes
• VOC: 0 g/l